Tait tm8200 User Manual

Operating in conventional mode 27
Ending all active calls by using a function key
Press the function key programmed for call cleardown and
monitor is turned off for all radios in your radio group.
Any call in progress or incoming call is ended, the green LED
stops flashes and the monitor symbol disappears from the
display.
Ending active calls by using the function key
programmed for reset monitor/call cleardown
The function key programmed for reset monitor may be
programmed so that:
■ a short key press ends your current call, and
■ a long key press ends all active calls in your group.
Activating the repeater before a call
A repeater-access tone is sent to activate the repeater before a
call is made, so that the start of the call is not lost. To send a
repeater-access tone, you may be able to either:
■ use the PTT key, or
■ use a programmed function key.
Sending a repeater-access tone using the PTT key
1 Press the PTT key and the repeater-access tone for the
current channel is sent.
The call details appear in the display, the red LED glows and
the transmit symbol appears in the display. You may also
hear signalling tones.
2 Press and hold the PTT and proceed with your call.
Sending a repeater-access tone using a
function key
1 Press the function key programmed for sending a
repeater-access tone, and the repeater-access tone for the
current channel is sent.
The call details appear in the display, the red LED glows and
the transmit symbol appears in the display. You may also
hear signalling tones.
2 Press and hold the PTT and proceed with your call.

Tait tm8200 Specifications

General

Operating Temperature Range	-30°C to +60°C
IP Rating	IP54
Channel Spacing	12.5 kHz, 25 kHz
Battery Life	N/A (Mobile Radio)
Frequency Range	136-174 MHz, 400-470 MHz