Tait tm8200 User Manual

26 Operating in conventional mode
2 Press the low-power transmit function key again to turn
low-power transmit off.
The message Low power transmit
deactivated appears in the display.
Activating low power transmit by using the
Main menu
1 Select Menu>Radio Settings>
Function Settings>Low Power Transmit.
2 In the Low Power Transmit menu,
choose On.
3 Press Select.
The message Low power transmit
activated appears in the display. When
you next transmit, the low-power trans-
mit symbol appears in the display and the red LED glows.
Ending active calls
You may have a function key programmed to either end the
current call, or end the current call and all other active calls in
your group. This can be done either by:
■ using the function key programmed for reset monitor to
end your current call,
■ using the function key programmed for call cleardown to
end your current call and all other calls in your group, or
■ using the function key programmed for both reset monitor
and call cleardown.
Ending your current call by using a function
key
Press the function key programmed for reset monitor. The
radio’s monitor is turned off, ending your current call.
The green LED stops flashes and the monitor symbol disap-
pears from the display.

Tait tm8200 Specifications

General

Operating Temperature Range	-30°C to +60°C
IP Rating	IP54
Channel Spacing	12.5 kHz, 25 kHz
Battery Life	N/A (Mobile Radio)
Frequency Range	136-174 MHz, 400-470 MHz