Tait tm8200 - Placing the Radio in Do-Not-Disturb Mode

Operating in MPT trunked mode 47
Placing the radio in do-not-disturb mode
If you do not want calls for a while, you can place the radio in
do-not-disturb mode, so that incoming calls can be ignored.
You can make outgoing calls in the usual way.
Note: While do-not-disturb mode is active, incoming calls
cannot be stored in the call queue.
To place the radio in do-not-disturb mode, you may be able
to either:
■ use a programmed function key, or
■ use the Main menu.
Activating do-not-disturb mode by using a
function key
1 Press the function key programmed for do not disturb, to
activate the do-not-disturb function.
The message Do not disturb activated appears in the
display. Your radio will now ignore all incoming calls.
2 To deactivate the do-not-disturb function, press the do-not-
disturb function key again.
The message Do not disturb deactivated appears in the
display.
Activating do-not-disturb mode by using the
Main menu
1 Select Menu>Radio Settings>
Call Settings>Do not disturb.
2 In the Do Not Disturb menu, choose
On.
3 Press Select.
The message Do not disturb activated
appears in the display. Your radio will
now ignore all incoming calls.