Operating in MPT trunked mode 39
Dialling a PABX number
If your radio has a keypad microphone installed, you may be
able to make calls to a PABX extension. For information about
entering characters using the keypad microphone, see “About
the keypad microphone” on page 5.
To dial a PABX extension:
1 Dial n, where n is the PABX extension
you wish to call.
2 Press Send or the or PTT key.
The call details appear in the display.
While the call is being setup, you can
cancel the call by pressing Clear.
Dialling a PSTN number
If your radio has a keypad microphone installed, you may be
able to make calls to a PSTN number. For information about
entering characters using the keypad microphone, see “About
the keypad microphone” on page 5.
To dial a PSTN number:
1 Dial 0n, where n is the PSTN number you
wish to call.
Note: The numbers you dial before the 0
depend on the way your
network operates.
2 Press Send or the or PTT key.
The call details appear in the display.
While the call is being setup, you can
cancel the call by pressing Clear.
Receiving a call
When you receive a call, your radio displays
the caller’s identity and responds in one of
two ways, depending on the way it was
programmed and the way your
network operates.
To Next Page
Loading...
