User guide Advanced menu
101
Paper width (Pagewid) This parameter determines the actual paper width.
Select the Pagewid menu (3)
Setting options: From 20 to 136 in 1/10 inch steps
Default setting: 136/10 inch
(136 characters at 10 characters/inch)
If Head up = On, the printhead moves to the calculated centre of the
paper during the time the paper is moving in the protected zone. If
Rightzo = On (see below), the printhead moves out of the perforation
zone on the right as long as the paper is being transported.
Set the printing width rather than the actual paper width.
Confirm your settings with the Set key (1) and press the Next key (4)
to access the next group of parameters.
Left-hand area (Leftzon) If the parameter is On, the printhead moves out of the perforation
zone (area) on the left as long as the paper is being transported. The
Pagewid setting has no influence (see above).
Select the Leftzon menu (2) (stands for left zone).
Setting options: On/Off
Default setting: Off
Confirm your settings with the Set key (1).
Head up Pagewid
Online
Setup
Back Next
21
3
4
Pagewid=136/10"*
Online
Setup
Set < > Exit
21
3
4
Leftzon Rightzo
Online
Setup
Back Next
21
3
4
Leftzon=Off *
Online
Setup
Set < > Exit
21
3
4
To Next Page
Loading...
