TallyGenicom 2265+ - Page 154

Emulations User guide
144
✓
✓✓
<ESC>*<4><n1> <n2> Set graphics print to 80 dpi
✓
✓✓
<ESC>*<40><n1> <n2> Set graphics print to 360 dpi
✓
✽✽✽✽
<ESC>*MI>F Assign character set G2
✓
✓✓
<ESC>-<n> Underlining ON/OFF
✓
<ESC>/<m> Select vertical tab channels
✓
<ESC>. Printing raster graphics
✓
✓
<ESC>: Condensed printing 12 cpi ON
✓
✓
<ESC>:<0><n><m> Copy ROM character set
✓
✓
<ESC>< Unidirectional printing for 1 line
✓
✓
<ESC>= Set bit 8 = 0
✓
✓
<ESC>=<C1><C2>... Load font/character set
✓
✓
<ESC>> Set bit 8 = 1
✓
✓
<ESC>?<s><n> Reload a graphics mode
✓
✓
<ESC>@ Initialize printer
✓
✽✽✽✽
<ESC>[ MTPL start character for programming sequence
✓
✽✽✽✽
<ESC>[+0<u> Compmode = On
✓
✽✽✽✽
<ESC>[+1<u> Compmpde = Off
✓
✽ ✽✽ ✽
<ESC>[:y Right justification and centering OFF
✓
✽✽✽✽
<ESC>[=z Bold ON
✓
✽✽✽✽
<ESC>[>z Bold OFF
✓
✽✽✽✽
<ESC>[?1~ MTPL command set
✓
✽✽✽✽
<ESC>[?10~ Barcode interpretation OFF
✓
✽✽✽✽
<ESC>[?11~ Start barcode interpretation
✓
✽✽✽✽
<ESC>[?4~ MTPL + IBM Proprinter-24 command set
✓
✽✽✽✽
<ESC>[?50h Selecting character sets with 256 characters
✓
✽✽✽✽
<ESC>[?50l Selecting character sets with 94 characters
✓
✽✽✽
<ESC>[?51h Proportional fonts automatic NLQ and LQ
✓
✽✽✽
<ESC>[?51l Proportional fonts in draft mode possible (default)
✓
✽✽✽✽
<ESC>[?52h
Font selection (ESC[10...19m]) possible only for NLQ and LQ
✓
✽✽✽✽
<ESC>[?52l Font selection (ESC[10...19m]) Draft possible (default)
✓
✽✽✽✽
<ESC>[?53h Extended character set
✓
✽✽✽✽
<ESC>[?53l Standard character set
✓
✽✽✽✽
<ESC>[?6~ MTPL + EPSON LQ command set
✓
✽✽✽✽
<ESC>[?7h Line overrun = CR + LF
✓
✽✽✽✽
<ESC>[?7l Line overrun = Truncating data outside of the printing area
✓
✽✽✽✽
<ESC>[?<n>~ Change emulation
MTPL
IBM
XL24
IBM
AGM
Epson
LQ-2550
Epson
LQ-2170
Code Function