User guide Table of contents
III
Menu parameters 61
Printing out menu configurations (Print) 61
Loading menu configurations (Menu) 61
Reset to default values (Reset) 62
Quietmode (Quietm.) 62
Selecting font (Font) 63
Setting character density (CPI) 64
Setting line spacing (LPI) 64
Skiping perforation (Skip) 65
Selecting start signal for escape sequence (ESCChar) 65
Selecting emulation (Emulate) 66
Bidirectional printing (Bidir) 66
Settings for interfaces (I/O) 67
Serial interface (Serial) 67
Data transmssion rate (Baud) 67
Data format (Format) 68
Further Settings (Special) 69
Error handling (ErrMode) 69
Block end character (Blockend) 69
Signal feedback (Remote) 70
Transparence (Handthr) 70
Protocol (Protocol) 71
Signal Processing (DTR) 71
Selecting interface (Interf.) 72
Interface buffer (Buffer) 72
Ethernet interface (ETH-INT) 73
Setting IP address (IP Addr) 73
Setting Gateway address (Gateway) 73
Setting Subnet mask (Subnet) 74
IP address administration (IP Get M) 75
Banner page (Banner) 75
Selecting character set (CG-Tab) 76
IBM character set (CharSet) 76
National character set (Country) 77
Slashed zero (Sl.Zero) 77
Automatic carriage return (Auto-CR) 78
Automatic line feed (Auto-LF) 78
Menu lock (MenLock) 79
Language (Language) 79
To Next Page
Loading...
