What’s in this guide? Getting started Making calls Using the phone book In-call features Video conferencing
26
D1403405 USER GUIDE VIDEO ENDPOINTS MXP ENGLISH—SEPTEMBER 2009
Making calls
Calling two others simultaneously …
T
he MultiSite capability is an optional
feature in many TANDBERG
systems. This feature gives you the
possibility of arranging video meetings
by calling several others and have you
all connected together simultaneously.
For more on this, see About video
conferences.
Video systems not equipped with
MultiSite may still call another party
when already in a call.
Thus you may even here have two
calls running at the same time. Note
that the two parties will not be able to
communicate with each other, only with
you and only one at a time. The feature
requires H.323 or SIP to work.
If you are not sure whether your system
has this feature, contact your system
administrator.
When you make an additional call, the
party called first will be temporarily
suspended. The message “Please wait”
will appear on the screen of the party
suspended.
You may switch between the two
parties you have called by navigating to
the lowermost line in the main menu as
shown on this page.
This feature is not available on systems
with MultiSite installed.
Both calls made must be SIP or H.323
in order to make this feature work. This
feature is available on non-MultiSite
systems only. If in doubt, ask your
system administrator.
Calling two others at the same time
Non-MultiSite systems only!
If you select Add
another Call
during a call (press
the OK key on the
remote control
during the call)
and then
press the OK
key again…
… the call currently active will be
temporarily be set On Hold, which
can be seen from this line.
Call the second party
manually or by means of
the phone book in the usual
manner.
To switch
between the
two parties,
navigate
down to
this line and
press the
OK key on
the remote
control.
To terminate just one
of the calls, use the
Arrow keys to navigate
to that number and
press the red End Call
key on the remote
control. If you want to
terminate both calls at
the same time, press
the red End Call key
again.
To end any or both of the calls,
press the End Call button on
the remote control. The menu
will then look something like
this…
To Next Page
Loading...
