11 - Various Other Functions
7. After tuning the instrument, press the HOME
button to return to the Home screen.
NOTE
The following buttons can be controlled in the Tuner
mode.
INPUT TRIM (Analog)
JOG/DATA dial (Calibration)
Monitor level
Setup (PREFERENCE)
You can use the
PREFERENCE
screen to change various
settings to optimize the unit for your use environment
and other requirements, as well as to restore the factory
settings.
The PREFERENCE menu allows you to customize the unit
to your preference.
Follow the procedure below to open the
PREFERENCE
screen.
1. When the recorder is stopped, press the MENU
button to open the
MENU
screen.
2. Use the JOG/DATA dial or the CURSOR (5/b/g/
t) buttons to select
PREFERENCE
, and then press
the F4 (t) button.
The
PREFERENCE
screen appears.
3. On the
PREFERENCE
screen, use the CURSOR
(5/b) buttons to select a parameter, and then use
the JOG/DATA dial to change its setting.
Contrast (LCD adjustment)
•
Brightness (LCD adjustment)
•
Backlight (LCD adjustment)
•
Foot SW Right (Foot switch R assignment)
•
Foot SW Center (Foot switch C assignment)
•
Foot SW Left (Foot switch L assignment)
•
Undo History (Switch over between level 1 and level
•
10)
Jump Back (Jump time setting)
•
Auto Monitor (Auto Monitor setting)
•
Preview Time (Preview time setting)
•
Song Name Type (Switching between DATE and
•
WORD)
Date/Time (System time/date setting)
•
Initialize (Factory setting reset)
•
Auto Monitor
When stopped and the Recorder function is enabled, the
input monitoring becomes possible.
The Auto Monitor starts playback, mutes the input sound,
and provides the monitoring of the playback sound only.
OFF (Default):
Even when the playback starts, the input sound is not
muted.
When the Recorder function is ON, the input sound
and the playback sound are mixed.
ON:
When the playback starts, the input sound is muted.
When the Recorder function is ON, only playback
sound is heard.
To Next Page
Loading...
Need help?
General
