14 - Using CDs
Ejecting a CD
1. When Recorder mode is
Multi Track
mode,
press the CD button to open the
CD
menu screen.
2. Press the F3 (-) button or the disc tray eject
button on the front panel to open the tray slightly,
and then pull the tray out until it opens completely.
Hold the disc by its edges and lift it out.
CAUTION
Do not lift the disc forcibly. Doing so could damage the
unit or the disc.
Forcing disc ejection
If the disc is not ejected even when you press the F3 (-)
button of the
CD
menu screen or press the disc tray eject
button on the front panel due to a failure of the CD drive,
etc., you can eject the disc by using the emergency eject
button (emergency eject hole).
Before using the emergency eject function, turn the
power off (standby), disconnect the AC adapter from the
unit, and follow the procedure below.
1. Prepare an extended clip or another similar object.
2. Insert the extended clip into the emergency eject
hole and press the inner button a couple of times.
3. When the disc tray opens slightly, use your hand to
pull it out.
CAUTION
Use this function only in an emergency. Normally,
•
remove the disk by the usual procedure. (See "Ejecting
a CD" above.)
Never perform the disc emergency ejection when
•
power is ON.
Playing back an Audio CD
1. Press the CD button to open the
CD
menu screen.
2. Load an Audio CD.
3. Use the JOG/DATA dial to select (blue highlight)
PLAY/IMPORT
and then press the F4 (t) button.
The
CD PLAYER
screen appears and the CD drive
works as a CD player.
1 This shows the number of the track currently
playing back.
2 This shows the numbers and times of each track.
You can use the JOG/DATA dial to move the
selected track up and down. When the CD player is
stopped, press the PLAY (7) button to play back
the selected track.
3 This shows the elapsed time from the beginning
of the track currently playing back.
4 This is the level meter of the audio recorded on
the CD. The playback signal sent from the CD to
the MONITOR OUT jack or PHONES jack of this
unit cannot be adjusted with the STEREO fader.
4. When the
CD PLAYER
screen is displayed, you can
use the JOG/DATA dial and other buttons to control
the CD player.
Button/dial Description
JOG/DATA Selects the track for playback.
STOP (8 )
Stops the CD player.
PLAY (7)
Plays back the selected track
when pressed when CD
player is stopped.
REW (m)
(TO ZERO)
Skips to previous track when
near the beginning of a track.
Returns to the beginning of
the current track when in the
middle of a track.
F FWD (,)
(TO LAST REC)
Skips to the next track.
STOP (8 )
+ REW (m )
(TO ZERO)
Skips to the first track on the
CD and stops.
F2 (4)
Selects the track to be
imported.
F3 (-)
Stops the playback and opens
the disc tray.
F4 (t)
Executes the import.
To Next Page
Loading...
Need help?
General
