EasyManuals Logo

TC Electronic SYSTEM 6000 MKII Algorithm Manual

TC Electronic SYSTEM 6000 MKII
124 pages
To Next Page IconTo Next Page
To Next Page IconTo Next Page
To Previous Page IconTo Previous Page
To Previous Page IconTo Previous Page
Page #62 background imageLoading...
Page #62 background image
62
MD 5.1
Limiter
The Limiter page is divided into three Sub-pages. One
coveringtheSoftclipsection,onefortheFullRangeLimiter
andonefortheLFELimiter.
Generic parameters in this algorithm:
Meter Zoom
Press Meter Zoom to decrease meter range and have a
more accurate metering.
Bypass Limiter
PresstoBypasstheLimitersectionofthe5.1algorithm.
Soft Clip page
Softclip
Full Range Softclip
Range: -6dB to Off
Softclipper Threshold setting after the Compressor for the
five multiband channels. Threshold is always relative to
0dBFS(NottheReferenceLevel).
LFE Softclip
Range: -6dB to Off
SoftclipperThresholdsettingfortheLFEchannelonly.
Full Limit. page
Threshold
Range: -12dB to Off
-6 to OdB in 0.1dB increments
-12to-6in0.5dBincrements
Brickwalllimiterforthefivemultibandchannels.Threshold
isalwaysrelativeto0dBFS.LEDoneachOutputmeter
indicates when Limiter is active.
Release
Range: 0.01 to 1.00 seconds
Release time for the Limiter.
Ceiling
Range: -0.10dB to 0dB
Fine-tuningparametersettingtheCeilingfortheLimiter.
The Ceiling parameter prevents the Output signal
fromexceedingtheadjustedLimiterThreshold.It
canbeusedto“hide”overloadstodownstream
equipment, but it does not remove the distortion
associated with an over.
LFE Limiter page
LFE Limiter
Threshold
Range:-12to+3dB
-6to+3in0.1dBincrements
-12to-6in0.5dBincrements
BrickwalllimiterfortheLFEchannel.Thresholdisalways
relativeto0dBFS.LEDoneachOutputmeterindicates
when limiter is active.
Release
Range: 0.01 to 1.00 seconds
Release time for the Limiter.
Ceiling
Range: 0 to -0.10dB in 0.01dB steps.
Fine-tuningparametersettingtheCeilingfortheLimiter.
The Ceiling parameter prevents the Output signal
fromexceedingtheadjustedLimiterThreshold.It
canbeusedto“hide”overloadstodownstream
equipment, but it does not remove the distortion
associated with an over.

Other manuals for TC Electronic SYSTEM 6000 MKII

Questions and Answers:

Question and Answer IconNeed help?

Do you have a question about the TC Electronic SYSTEM 6000 MKII and is the answer not in the manual?

TC Electronic SYSTEM 6000 MKII Specifications

General IconGeneral
BrandTC Electronic
ModelSYSTEM 6000 MKII
CategoryComputer Hardware
LanguageEnglish

Related product manuals