- 22 -
2.2.3 MAINTENANCE OF BEARINGS
The service life of bearings varies with the magnitude of loads and operating conditions.
Replace the bearings with new ones when the temperature rises excessively or produces noise.
Sealed bearings sealing in lithium soap-based grease ensure effective lubrication and prevent
the entrance of dust. They can be used for a long period of time without adding grease.
The sealed bearing should be replaced using the following table as a rough guide.
Operation time 8 – 12 hours/day 12 hours/day
Replacement intervals Once every 6 years Once every 3 years
Earlier replacement may be required if the motor is used at a place which is dusty or might
cause the sealed grease to deteriorate or flow out due to the atmosphere of harmful gases or
solvent.
■ Installing bearing
Install the bearing onto the shaft using a pipe (with a patch, if needed), as shown in Figure 2.8.
When heating the bearing, do not heat to more than 60 to 80°C [140 to 176°F].
Fig. 2.8
PATCH
■ Removing bearing
Using a puller, remove the bearing.
Fig. 2.9
INTERNAL
BEARING COVER
NUT
PULLER BOLT
BEARING
2. MOTORS
To Next Page
Loading...
