5.2.5 ADJUSTING BRAKE PEDAL
(1) Shorten the push rod length of the master cylinder.
(2) Using the stopper bolt, adjust the pedal upheight to the value shown in Figure 5.29.
(3) Keeping the pedal pressed down by the pedal play, extend the push rod so that its tip contacts
the piston of the master cylinder.
(4) Securely tighten the push rod by its lock nut.
ペダル高さ：97mm（FB10～25）
110mm（FB30～35）
Fig. 5.29
BRAKE SWITCH
Brake switch operating direction:
5 – 10 mm [0.2 – 0.4 in.]
■ Adjusting brake switch
(1) Make sure that the pedal upheight is the value shown in Figure 5.29. Loosen the brake switch
lock nut.
(2) Remove the brake switch lead wire from the connector.
(3) While turning the brake switch and pressing down the brake pedal by 5 to 10 mm [0.2 to 0.4
in.], check and nd the position where the switch turns ON.
(4) Secure the brake switch with the lock nut.
Pedal height: 97 mm [3.8 in.] (FB10 - 25)
110 mm [4.3 in.] (FB30 - 35)
To Next Page
Loading...
