01. CAUTION TO TAKE WHEN SERVICING THE TRUCK
* Before servicing the truck, make sure to:
1. Park the truck on a level surface and jack up the drive wheel off the oor or ground.
Make sure there is no obstacle above and around the truck before operating the load handling
system.
* Caution to take when measuring, inspecting or repairing:
2. Before connecting or disconnecting wire harness couplers, make sure the key switch is turned off
and the battery receptacles are disconnected.
3. When measuring the resistance of wire harness couplers with a multimeter, connect the probes to
the lead wire side of the coupler.
4. When inspecting the truck with the forks raised, support the forks to prevent them from falling
unexpectedly.
5. When inspecting the truck with the mast advanced, put a pallet between the mast and the front
guard of the truck to prevent the mast from retracting unexpectedly.
6. Inspection and repair of the truck must be performed only by qualified service personnel
authorized by TCM.
Reach model
Counterbalanced model
To Next Page
Loading...
