TDK-Lambda GH10-150 - Page 134

123
SYSTem:FRST <DSC>
Function Restores factory default parameters and sets communication interface
according to <DSC> parameter.
Refer to Table 2-6 & Table 2-7.
Parameters 1|2|3|4|5, USB|RS232|RS485|LAN|OPTion
SYSTem:FRST without a parameter sets USB communication interface.
NOTES
1. Factory Reset does not affect advanced parallel configuration acknowledgment (does not affect
power supply configuration (Single, Master or Slave roles does not change).
2. Execution time for this command is ~250mS.
3. <DSC> Parameter is available for firmware revision 02.106 and above.
SYSTem:FIRMware[:VERSion]?
Query Returns firmware versions string: Interface, Master Control, Display, and
Option (if available).
Return
<SRD> xx.xxx,xx.xx,x.x,xx.xxx
NOTE
Option firmware revision (last xx.xxx field) is seen if the query is sent through optional
communication interface.
SYSTem:PANel:LOCK?
Query
Returns the front panel unlocked (0)/locked (1) state.
Return
<Bool> 0|1
SYSTem:PARallel?
Query Returns the Master/Slave setting
Single, Master + # or Slave
Return
<SRD> SINGLE|MASTER+#|SLAVE
NOTE
# represents the number of slave units connected.
SYSTem:PARallel:ACKNowledge
Function
Accept present parallel configuration.
SYSTem:PON:TIME?
Query Returns the total time power supply is connected to AC & Power Switch
is ON. Max value: 2
32
-1
Unit
Minutes
Return
<NR1>