TDK-Lambda GH10-150 - Page 133

122
SYSTem[:COMMunicate]:LANGuage <DSC>
Function Sets the communication protocol to GEN language.
GEN language is available in RS232/485 and USB.
Parameter
GEN
Query
SYSTem[:COMMunicate]:LANGuage?
Return
<DSC> SCPI
NOTE
SYSTem[:COMMunicate]:LANGuage GEN command returns -220 “Parameter Error” to
SYSTem:ERRor? query if sent via LAN or optional communication interface. LAN or optional
communication interfaces do not support GEN language.
SYSTem[:COMMunicate]:WATCHdog[:STATe] <Bool>
Function
Enable or disable communication watchdog
Parameter
0|1, OFF|ON
Query
SYSTem[:COMMunicate]:WATCHdog[:STATe]?
Return
<Bool> 0|1
SYSTem[:COMMunicate]:WATCHdog:TIMe <NR1>
Function
Set communication watchdog timeout (in seconds)
Parameter
1…3600|MIN|MAX Step:1
Unit
S
Query
SYSTem[:COMMunicate]:WATCHdog:TIMe?
Return
<NR1> 1…3600
SYSTem:DATE?
Query
Returns the date of last calibration. Format yyyy/mm/dd
Return
<SRD>
Example
2017/12/17
SYSTem:ERRor:ENABle
Function
Enables log of last 10 Error messages.
SYSTem:ERRor?
Query Returns an error number and a corresponding error message stored in an
error queue. Works as FIFO. When no error exists 0,”No error” is returned.
If Buffer reaches above 10 messages, the command returns -350,”Queue
Overflow”.
Return
<SRD>
Example
0,”No error”