4.3 System Information tab
4.3.1 General Information
Figure 4-3: System Information tab
On the “System Information“ tab some status information about the device is
displayed. You can check the version number of the application firmware and the
bootloader. The version number registers of the switch and PHY chips are displayed
for information. If these registers are displayed as “FFFFFFFF”, this port/PHY is defect.
Rotary Switch: The configuration of the Rotary switch is displayed here.
Hardware version: The version of your Hardware is displayed here.
MAX10 Version: The Current Version of the MAX10 Chip is displayed here.
To Next Page
Loading...