Technica CM 100 High User Manual

CM 100 High User Manual
20
4.3.2 IP addresses
The IP address can be changed in the field as shown in FIGURE 4-4:
Figure 4-4: IP-addresses
There are two possibilities to get access to the device:
• Access by 100BASE-T1 port of the power connector at the frontside
• Access by the GB-Port which is activated as configuration port. By default, it is
GB-A
Controller IP address: This is the IP address you get access to the Webserver by the
100BASE-T1 port. This IP-address can be changed here. Please type the new IP-
address in the field. After leaving the focus of this field or pressing “Enter” you can
save the changes.

Technica CM 100 High Specifications

General

Brand	Technica
Model	CM 100 High
Category	Control Unit
Language	English