5 APPLICATION AND FIRMWARE UPDATE
You can download the latest firmware and documentation for the CM_100_High here:
https://technica-engineering.de/en/produkt/capture-module-100-high/
5.1 Preconditions and important information
Warnings
Please do not downgrade the bootloader or application to a former version. This
could cause serious problems.
Please follow this update instruction to avoid erroneous states of the device.
Technica Engineering may charge support fees for repair service.
Only upgrade to the latest firmware. And always bootloader and application
Firewall must be deactivated, or Port 69 and Port 9000 must be open
You need a stable 12 Volt DC power supply. Do not switch off the power supply
during the update process!
Notes
You need administration privileges on your Windows system to do the firmware
update on the CM_100_High.
Make sure, you have installed the latest Java 8 version (e.g. Java 8 update 191).
Make sure your network-adapter is configured in the correct IP-address range
If an error occurs during update, do a power reset and please try again.
To Next Page
Loading...
Need help?
General