GROUP CYCLE: Service & Maintenance manual rev. 6.4
Page 5.2
5.2 E6 ERROR ON THE WIRELESS CONSOLE
The error E6 is displayed in case of the communication is missing between the receiver in the
display and the transmitter on the flywheel.
If the error appear, follow the below procedure to fix it.
1. Remove the batteries from the display.
2. Insert the same batteries again while keeping any key depressed.
3. Press the RETURN key and check the code appearing on the lower frame of the display. This
code must match the code printed on the transmitter.
4. Press and hold the PLAY key; the display visualises code 0000.
5. Set the same code as that appearing on the transmitter: press the INCREASE or DECREASE
key to modify the single digit; press the PLAY key to skip to the next digit.
To Next Page
Loading...
