Technogym GROUP CYCLE - Saddle and Handlebar Adjustments

GROUP CYCLE: Service & Maintenance manual rev. 6.4
Page 6.1
6 DISASSEMBLY OF COMPONENTS
6.1 DISASSEMBLING HANDLEBAR
Figure 6.1-1
1. Lift up the lever (a) as indicated by arrow.
2. Remove the upright (b) upward.
3. Back off the screws (c) on both sides, using a
5mm hexagonal
wrench, to remove the
handlebar from the upright.
To reassemble the handlebar, carry out the
above steps in reverse order.