Technogym GROUP CYCLE - Disassembling Pedal Pedal Cage and Pedal Cranks; Disassembling the Pedal

GROUP CYCLE: Service & Maintenance manual rev. 6.4
Page 6.6
6.5 DISASSEMBLING PEDAL, PEDAL CAGE AND PEDAL
CRANKS
6.5.1 DISASSEMBLING THE PEDAL
Figure 6.5-1
1. Back off the grub screw (a) fro
m the internal
side of the pedal crank
, as shown in the
figure at side.
ATTENTION: the grub screws (a
) are
different for right and left pedal.
Figure 6.5-2
2. Back off the pedal (b) using a 15mm wrench
(figure 1) or using a 6mm hexagonal wrench
(figure 2) from the rear side.
3. Remove the pedal.
To avoid the loosening of the pedals, please
carefully carry out the re-assembling procedure,
detailed here following.