Technogym GROUP CYCLE - The Machines Is Not Flat

GROUP CYCLE: Service & Maintenance manual rev. 6.4
Page 7.10
7.7 THE MACHINES IS NOT FLAT
This problem may be due to the positioning of the machine on a not flat surface. To resolve this
problem is necessary to act on foot adjustment.
Figure 7.7-1
The machine is levelled by adjusting the two rear feet:
1. For each foot back off the lock-nuts (b) and screw or unscrew the foot (a) until the frame is in a
stable position.
2. After completing the adjustment, tighten the lock-nut (b).