Technogym GROUP CYCLE - Disassembling Bushes Adjustment Lever of Seddle and Handlebar

GROUP CYCLE: Service & Maintenance manual rev. 6.4
Page 6.3
6.3 DISASSEMBLING BUSHES ADJUSTMENT LEVER OF
SEDDLE AND HANDLEBAR
Figure 6.3-1
For both bushings:
1.
Remove the saddle group and/or the
handlebar group.
2.
Force towards the inside of the frame the
plastic tab with the pin (a)
, using a flat
Phillips screwdriver. At the same time
remove the bushing pulling it up.
Figure 6.3-2
3. Remove the lever (b)
from the inside of the
frame, as shown by arrow in the figure at the
side.
To reassemble the bushing and the adjusting
lever, carry out the above steps in reverse order.