Technogym GROUP CYCLE - Disassembling the Sensor

GROUP CYCLE: Service & Maintenance manual rev. 6.4
Page 6.28
6.13.2 DISASSEMBLING THE SENSOR
Figure 6.13-3
Carry out the procedure described in paragraph:
6.4“Disassembling ”, up to step (3).
1. Back off the screw (a)
using a medium
Phillip screwdriver.
Figure 6.13-4
2. Back off the 2 screws (b) using a 4mm
hexagonal wrench.
3. Remove the group (c).
Figure 6.13-5
4. Remove the sensor (d)
and replace if is
necessary.
To reassemble the components removed, carry
out the above steps in reverse order.