Technogym GROUP CYCLE - Page 40

GROUP CYCLE: Service & Maintenance manual rev. 6.4
Page 6.20
Figure 6.8-3
1. Reassembly the flywheel if previously
disassembled.
2. Open the connecting link of the new chain
and pass it on the front pinion (d).
3. Pass the chain on the rear toothed wheel (e)
and then close the connecting link.
After reassembling carry out the
procedure at paragraph: 7.1“
Adjusting
the CHAIN tension and flywheel
parallelism”.
CAUTION: It’s a common behaviour of
a NEW CHAIN the fact it can increases
its length during the first hours of
functioning. We can estimate that in
about 1% of its total length equal to
13mm, after a period of 40-
50 hours of
usage. Then it’s p
ossible that after this
time a sort of “play” on the pedals is felt
by the user due to the loosening of the
chain tension and this should be
adjusted again.
We want to remind you that this is a
standard maintenance procedure
detailed in the user manual a
nd which
the customer can do by himself.