Technogym GROUP CYCLE - Page 43

GROUP CYCLE: Service & Maintenance manual rev. 6.4
Page 6.23
Figure 6.10-4
During the reassembly take care of the parts order, as detailed above; pay particular
attention to the parts (2) and (4).
Figure 6.10-5
Before reassembly the flywheel group,
replace the belt on the secondary pulley.
1. Insert a wrench into the flywheel
shaft hole
and lift it up to put it on the it’s frame
housing, as shown in the figure at the side.
Figure 6.10-6
2. Place the shaft on the opposite side and insert
up to completely
replace the previously
inserted wrench.