Technogym Skillmill GO - TROUBLESHOOTING & CONFIGURATION; 6.1 EXECUTABLE SW FOR DIAGNOSTICS WITH PC

6. TROUBLESHOOTING & CONFIGURATION
 

6.1 EXECUTABLE SW FOR DIAGNOSTICS WITH PC
1. Connect the USB cable and wait 5 seconds until the LCD lights up;
 -

2. The rst time that the PC is connected with Skillmill or New Group Cycle (D92) or MYRUN
TECHNOGYM, the PC asks to install a driver for the detected device. Stop the automatic
search for the driver on Windows update and select the manual path on your PC where the
le was previously saved, which can be downloaded from TG Direct: myrun_usb_driver.inf.



 Terminal

The protocol described by the document denes the set of messages that can be sent to the equip-
ment. The messages are purely ASCII. This executable can be used to perform a series of reading
and diagnostic operations and receive the responses from the system.
3. Launch the software: Terminal.exe.
4. The rst time the program is executed, set a few seings on the screen as shown below:
Skillmill:
Technical Service Guide - Rev. 2.2
Page 37
e-mail: support@technogym.com