Technogym Skillmill GO - TROUBLESHOOTING; 6.5.1 THE DISPLAY DOES NOT TURN ON (CONNECT VERSION)

6.5 TROUBLESHOOTING
6.5.1 THE DISPLAY DOES NOT TURN ON (CONNECT VERSION)
The display does not turn on
Skillmill connect
Yes
Reconnect /
replace it
No
No
Yes
Replace the display
Yes
No
- RPM not present
- Effort level does not change
- RPM not present
- Effort level changes
REPLACE the RPM sensor
Lower the resistance to the minimum
and try to rotate the running
plaorm very quickly. The display
turns on
Adjust the posion of
the RPM sensor
The power supply is connected and
funconing (85 Vdc)
Power the display using a USB
socket. Does it turn on?
Rotate the tread belt
and try to change the
resistance. There are
two possibilies
REPLACE THE LOW KIT / display low
kit connecon cable
Skillmill
Technical Service Guide - Rev. 2.2
Page 50
e-mail: support@technogym.com