Technogym Skillmill GO - 6.3.1 STEPS NECESSARY FOR CONFIGURING THE SKILLMILL APPLICATION

6.3.1 STEPS NECESSARY FOR CONFIGURING THE SKILLMILL
APPLICATION
1. Download the “Equipment set up” APP, available for Android and IOS mobile phones.


2. Check that the customer has installed the Skillmill application on the Unity Self dashboard
using the Technogym app store pro.mywellness.com/store professional application.
3. Set the room in which UNITY SELF is located with the “Equipment set up” app; the room
must be the same where the Skillmill classes are held, that is what is published in the class
calendar of the club pro.mywellness.com/Planner/CalendarClass.
This seing makes it possible for the trainer, once the Skillmill app is opened, to conrm that
the class will be held as scheduled in the class calendar, in order to have all the participation
data of the individual Skillmill classes.
4. Congure Unity Self with a static IP and remember the IP address of unity self because it
must be used in the console conguration.
5. Check that the minimum installation requirements are respected (for details, see the Skillmill
minimum installation requirements document available on TG Direct).
6. Congure the consoles for the WiFi connection and for the connection with UNITY SELF
(seing on the Technogym Equipment Set Up APP plus switching on of the console to store
the data).
7. Assign the virtual number to the Skillmills based on the class layout.
 

Skillmill:
Technical Service Guide - Rev. 2.2
Page 47
e-mail: support@technogym.com