7. DISASSEMBLY
-
structions - Skillmill” available on the
Before starting with part disassembly,
disconnect the power supply from the
equipment.
7.1 NECESSARY TOOLS
•
•
• Ratchet wrench
•
•
•
•
• Gauge
•
•
•
17 mm
• Rubber hammer
•
7.2 DISASSEMBLING THE
CONSOLE
1. Remove the guard (interlocked).
2. Disconnect the two connectors.
3. Remove the display.
4. Remove the guard (display support).
7.3 DISASSEMBLING THE NFC
BOARD
1. Remove the smartphone support.
2. Remove the guard.
3. Remove the guard.
4. Remove the guard.
5. Disconnect the connectors.
6. Remove the guard.
7. Remove the NFC board.
7.4 DISASSEMBLING THE
CENTRAL HANDLEBAR
1. Remove the left guard.
2. Disconnect the two connectors.
3. Loosen the screws fastening the handle-
bar.
4. Remove the right guard.
5. Remove the screws fastening the handle-
bar (left side).
6. Remove the handlebar by removing the
screws (right side).
Skillmill:
Technical Service Guide - Rev. 2.2
Page 59
To Next Page
Loading...
