Tecnoalarm TP8-64 - 4. CONTROL BY CONSOLE; 4.1 ARMING; 4.2 DISARMING; 4.8 RELEASE OF PANIC ALARM

Index User Manual - TP8-64
2
3.8.3 Attributes 3-11
3.8.4 Learning 3-11
3.9 PROGRAMMING OF THE WIRELESS KEYS 3-11
3.9.1 Periods 3-11
3.9.2 Association buttons 3-12
3.9.3 Attributes 3-12
3.9.4 Learning 3-12
3.10 PROGRAMMING OF THE CONSOLES 3-13
3.11 EXCLUSION OF MODULES/ZONES 3-13
3.11.1 Exclusion of zones 3-13
3.12 TEST 3-14
3.12.1 Zone test 3-14
3.12.2 Indoor siren test 3-14
3.12.3 Outdoor siren test 3-14
3.12.4 Viewing of the firmware version 3-14
3.12.5 Viewing of the vocabulary version 3-14
3.12.6 Viewing of the LED status 3-14
3.12.7 GSM module test 3-15
3.13 ENABLING OF REMOTE ACCESS 3-15
4. CONTROL BY CONSOLE
4.1 ARMING 4-4
4.1.1 Arming with master code 4-6
4.1.2 Arming with standard user code 4-7
4.1.3 Quick arming (if enabled) 4-7
4.1.4 Arming through key zone 4-8
4.1.5 Automatic arming 4-8
4.1.6 Arming during access periods 4-8
4.1.7 Arming denied 4-9
4.2 DISARMING 4-9
4.2.1 Disarming with master code 4-9
4.2..2 Disarming with standard user code 4-9
4.2.3 Disarming under duress (if enabled) 4-10
4.2.4 Quick disarming (if enabled) 4-10
4.2.5 Disarming through key zone 4-10
4.2.6 Automatic disarming 4-10
4.2.7 Disarming during access periods 4-10
4.3 BY-PASS 4-10
4.3.1 By-pass activation with code 4-10
4.3.2 Automatic by-pass activation 4-11
4.3.3 Activation of by-pass during the access periods 4-11
4.3.4 Deactivation of by-pass 4-11
4.3.5 Automatic deactivation of by-pass 4-11
4.3.6 Deactivation of by-pass on expiry of maximum by-pass time 4-11
4.4 ACTIVATION/DEACTIVATION REMOTE CONTROLS 4-12
4.5 MANUAL COMMUNICATOR BLOCK 4-12
4.6 VIEWING OF THE EVENT BUFFER 4-13
4.7 RESET OF LED SIGNALING 4-14
4.7.1 Reset of LED signaling with master code 4-14
4.7.2 Reset of LED signaling with installer code (tamper LED signaling) 4-14
QUICK COMMANDS - OPERATIONS WITHOUT CODE
4.8 RELEASE OF PANIC ALARM 4-15
4.9 VIEWING OF ZONE STATUS 4-15
4.10 VIEWING ALARM MEMORY 4-15