Removal and Installation Procedures
Cosmetic Co ver (Top)
You need a scr ew
driver with a T-15 Torx tip (items 1 and 2).
Removal. To remove the top cosmetic cover, follow the se steps: (See Figure 4-4
on page 4-11.)
1. Remove the snaps.
2. Remove the two screws (side) and three screws (top) securing the cosmetic
cover t o the chassis.
3. Loosen the cover with a detaching tool, such as a flat-blade screwdriver.
4. Tilt the rear side of the cover up, and then pull it off the chassis.
Installation. To install, reverse this procedure.
Cosmetic Cover (Bottom)
You need a screwdriver with a T-15 Torx tip (items 1 and 2).
Removal. To remove the bottom cosmetic cover, follow these steps: (See
Figure 4-4 on page 4-11.)
1. Removethehandleunit.
2. Orient the instrument so its top is down on the work surface and its rear is
facing you.
3. Remove the two screws (side) and three screws (bottom) securing the
cosmetic cover to t he chassis.
4. Loosen the cover with a detaching tool, such as a flat-blade screwdriver.
5. Tilt the rear side of the cover up, and then pull it off the chassis.
Installation. To install, reverse this procedure.
4–12 AWG7000B and AWG7000C Series Service Manual
To Next Page
Loading...
Need help?
General
