Removal and Installation Procedures
3. Remove the touc
h screen module:
a. Remove the two screws securing the touch screen module to the
front-panel b
racket.
b. Disconnect the cable from J200 on the LCDA board.
c. Lift the touch screen module away from the front-panel bracket.
4. Remove the LCD module:
a. Remove the four screws s ecuring the LCD module to the front-panel
bracket.
b. Disconnect the ca ble from J110 on the LCDA board.
c. Disconnect the cable from CN2 on the Inverter board.
d. Lift the
LCD module away from the front-panel bracket.
5. Disassemble the front-panel assembly components, using the following figure
as a gui
de.
Installation. To install, reverse this procedure.
AWG7000B and AWG7000C Series Service Manual 4–19
To Next Page
Loading...
