Tektronix TCP0030 - Page 26

Installation
Degauss/AutoZero
When the multicolor Degauss/AutoZero status
LED fla shes red, you must degauss the probe.
If the LED flashes orange, you should degauss
the probe. The DC gain and offset errors a re
not guaranteed when this LED flashes orange.
The Degauss/AutoZero function also clears
(AutoZeroes) any DC offset in the probe.
To degauss the probe , do the following:
1. Disconnect the probe from the current
source.
2. Press the Degauss/AutoZ ero bu tton to
initiate the degauss routine.
The LED glows green after successfully
completing the Degauss/AutoZero routine.
8 TCP0030 Current Pro be Instruction Ma nual