Tektronix TDS3000B Series - Probe Compensation; Tekprobe Interface

Appendix D: Probe Basics
D-2
TDS3000B Serie s User Manual
Probe Compensation
You should compensate a probe to an oscilloscope input whenever
you attach a probe for the first time to any i nput cha nnel. See
page 1--3 for instruc tions to compensate probes.
When compensating the P3010, only a djust the trimmer marked L.
L
TekProbe Interface
Probes with the TekProbe interface automatically communicate with
the oscilloscope to set the probe type and attenuation factor. If you
use a probe without the TekProbe interface, you can set these
parameters in the Vertical menu for the channel that the probe is
connected to.