192
Limit Test Options
Access this control window from the Mask menu and select Limit Test Setup….
Overview
Use these controls to set up test failure notification, lock the template
to a waveform, and highlight hits.
To Use
Click Config to open the Failure Notification control window where
you can set up the action you want your instrument to take if the limit
test fails.
Clicking the Lock Template to Waveform and Highlight Hits controls
will switch between on and off. If the control is off, click it to turn it
on.
Behavior
Clicking the Config button under Failure Notification activates the Failure Notification control
window. You can choose one or more actions that you want your instrument to take if the limit
test fails.
Turning on the Lock Template to Waveform locks the source waveform and template such that
adjusting the vertical position or scale of either affects both. Turning off Lock Template to
Waveform allows you to move the template and source waveform vertically, independent of each
other.
The default for Highlight Hits is On. When highlight hits is on, any points on the source waveform
that fall outside of the template are highlighted in a different color than the rest of the waveform.
To Next Page
Loading...
Need help?
General
