Tektronix TDS5104B

76
Autoset Undo Control Window
This control window opens automatically after an Autoset operation.
Overview
Use this control window to undo the last Autoset operation.
To Use
Click Undo. Only the parameters that were set by the last Autoset are undone.
Parameters that you changed that are not controlled by Autoset retain their
settings.
Behavior
The Autoset Undo control window remains on the screen until you open
another control window. After Autoset Undo closes, you can still undo the last
Autoset by selecting the Undo Last Autoset command from the Edit menu or
the Horiz/Acq menu. Although the last Autoset is immediately undone, the
Autoset Undo control window does not open again.