46
System Setup Window
HEADSET SETUP
The Headset Setup section is used to configure headset type and audio channel selection.
RHB 1 Headset Drop Down Menu
The RHB 1 Headset drop down menu is used to configure the headset type used on RHB 1.
NOTE: RHB 1 is connected to the REMOTE HEADSET 1 jack on the back panel.
Available selections for this field are: Mono and Stereo.
RHB 2 Headset Drop Down Menu
The RHB 2 Headset drop down menu is used to configure the headset type used on RHB 2.
Available selections for this field are: Mono and Stereo.
Controller Headset Drop Down Menu
The Controller Headset drop down menu is used to configure the headset type connected to the ADHB-4.
Available selections for this field are: Mono and Stereo.
RHB 1 Audio Drop Down Menu
The RHB 1 Audio drop down menu is used to configure RHB 1 to capture audio originating from the C-Soft’s Select or
Unselect channel. For mono-configured headsets, the audio is limited to Select only. For stereo-configured headsets, the audio
is routed from Select and Unselect.
Available selections for this field are: SEL Audio Only and SEL &UNSEL Audio.
RHB 2 Audio Drop Down Menu
The RHB 2 Audio drop down menu is used to configure RHB 2 to capture audio originating from the C-Soft’s Select or
Unselect channel. For mono-configured headsets, the audio is limited to Select only. For stereo-configured headsets, the audio
is routed from Select and Unselect.
Available selections for this field are: SEL Audio Only and SEL &UNSEL Audio.
Controller Headset Audio Drop Down Menu
The Controller Headset Audio drop down menu is used to configure the ADHB-4 to capture audio originating from C-Soft’s
Select or Unselect channel. For mono-configured headsets, the audio is limited to Select only. For stereo-configured headsets,
the audio is routed from Select and Unselect.
Available selections for this field are: SEL Audio Only and SEL &UNSEL Audio.
To Next Page
Loading...