Tempest 900 - Clear Memory; Restore Factory Default; Auxiliary Output; Reset Memory

36
Tempest900 2-Channel Operating Manual
Auxiliary Output
Audio from the Auxiliary OUT Connector can be assigned from any combination of the two intercom channels with Volume control at the “Aux
Out Assignment/Levels” menu. Audio from the Auxiliary OUT connector comes only from the wireless users and no audio from the hard wired
intercom channels is routed to Auxiliary OUT.
While in the “Aux Out Assignment/Level” menu, the front panel Channel Select (SEL) button is used to advance through the channels and the
OUT level control is used to adjust the Aux OUT volume. Adjust to OFF to restrict audio from a channel.
Audio levels are expressed in Decibels (dB). The audio range for Aux OUT are:
• Aux Out: -12 dB to +12
The Aux IN and OUT connectors are ¼” Tip/Ring/Sleeve jacks that accept standard ¼” TRS plugs. The Aux IN and OUT connections are balanced
and transformer isolated and operate at a nominal line level audio of - 4 to + 8 dBu.
Reset Memory
There are three options to reset memory: Restore Factory Default, Clear Memory, and Reset Radio Settings. Both the BaseStation and each
BeltStation have a “Factory Default” option in the “Tech Menu.” Browse to the “Tech Menu,” select “Factory Default,” and choose any of the
three options. From the BaseStation, “Restore Factory Defaults” only resets BaseStation defaults. BeltStation factory defaults can be reset in
each BeltStation and changes are relayed wirelessly to the BaseStation.
Restore Factory Default
This option will restore all settings to factory defaults except pairings and names.
Clear Memory
Occasionally, it may be desirable to remove all previous settings and user dened names, such as when equipment is transferred to a new
project or work site. Clear Memory on a BeltStation will require re-pairing of BeltStations. It may be necessary to select a Frequency Band due to
country specic RF requirements, on the BaseStation.
Reset Radio Settings
This is a BaseStation feature only. Selecting this option will only reset the Frequency Band to “1,” the Network Number to “0’” and the Lockout
Key to “255.” The BeltStation radio settings are determined by the BaseStation.
Be aware that restoring factory defaults will have an immediate effect on volume, sidetone, relay
selection, Aux In/Out levels, hard wired intercom levels, and Shared Slot settings, among others.
This option will restore all settings to factory defaults and will delete all user dened names. All entries
will be deleted and there is no “undo”.