Tempest 900 - Wireless Iso

45
Tempest900 2-Channel Operating Manual
iSelect Roaming – Selecting a BaseStation
Installations with multiple BaseStation coverage zones often require users to move from one work zone to another throughout the day.
One of the ways Tempest handles these transitions is with iSelect™ On-Command Roaming. Using iSelect, a user can easily change their
communication from one BaseStation to another BaseStation in just a few seconds.
• Conrm that the BeltStation has been paired with all required BaseStations.
• Conrm that there is an available slot on the desired BaseStation. If no slot is open, power OFF one of the connected BeltStations, wait
for 15 seconds, and proceed.
• Press MENU and select “Select Base.” Scroll to the desired BaseStation and press ENTER. Press MENU to exit.
Tempest Wireless BeltStations remember the last 64 BaseStations to which they have been paired.
Wireless ISO
Wireless ISO (isolate), sometimes referred to as wireless talk-around is a wireless-only intercom feature that allows communication among
wireless BeltStations only. When a wired intercom system is connected, Wireless ISO communicates through the wireless portion of the system
only. The BaseStation front panel headset does not receive ISO audio.
Wireless ISO is enabled by default and is available only on channel A. It is activated by pressing and holding ENTER. ENTER enables the
headset mic regardless of the “TALK A” button.
Wireless ISO only operates in Operational mode. It does not operate in Menu mode.