Tempest 900 - Navigate the Beltstation Menu; Remove Batteries from Beltstations; Install the Rechargeable Battery; Charge the Battery

63
Tempest900 2-Channel Operating Manual
How Do I …?
Remove Batteries from BeltStations
Remove the battery cover from the back of the BeltStation by pressing lightly on the thumb grooves and sliding towards the bottom. Hold the
BeltStation in one hand with the battery compartment facing downward over the open palm of your other hand. Firmly tap the BeltStation
against the palm of your open hand and the battery will fall into your open hand. Follow the same procedure for AA batteries.
Install the Rechargeable Battery
The gold battery contacts must mate with the contacts in the battery compartment. If the battery is not properly seated, the cover will not close
easily.
Charge the Battery
Connect the plug-in battery charger (included with BeltStation) to a standard wall outlet and to the Mini-USB connector on the BeltStation. This
connector is located under the rubberized access cover on the side of the BeltStation. The batteries will charge from completely empty to a full
charge in about 2¾ hours. The batteries will not overcharge. The BeltStation remains functional during charging.
Install AA Alkaline Batteries
Remove the battery cover on back of BeltStation. Insert (3) AA alkaline batteries according to the polarization shown inside the battery
compartment. Replace the battery cover. All batteries install with the positive terminal toward the side with Mini-USB charger connector.
Use the 5-Bay Battery Charger
Plug charger into local AC power source and place up to ve rechargeable, Lithium-Polymer batteries into the charger. Charging is complete
when the indicator turns green. Re-charge time is 2½ hours and the charge provides approximately nine hours of operation.
Navigate the BaseStation Menu
Press MENU to open the Main Menu. MENU also functions as an Escape key. Turn the Volume control to scroll through the menu. To select,
press ENT or press the Volume control. The keys numbered 1 through 5 under the LCD screen take you directly to the corresponding BeltStation
menu. If no entry is made within 3 minutes, the display will automatically return to the Operation Screen.
Navigate the BeltStation Menu
Press MENU to open the Main Menu. MENU also functions as an Escape key. Turn the Volume control to scroll through the menu. To select,
press ENT or press the Volume control. If no entry is made within a few seconds, the display will automatically return to the Operation Screen.