Tempest 900 - From the Beltstation; Configure Stage Announce and Sa Relay

64
Tempest900 2-Channel Operating Manual
Adjust Min/Max BeltStation Volume Levels
From the BeltStation:
• To set the Minimum volume, press MENU, select “Set Controls,” then “Volume Limit” and “Min Volume.” Use the Volume knob to
adjust the level and press ENTER to save the new setting.
• To set the Maximum volume, advance to “Volume Limit” as above, and then “Max Volume.” Use the Volume knob to adjust the level
and press ENTER to save the new setting.
From the BaseStation:
• Select the number key 1 through 5 that corresponds to the BeltStation desired and select “Volume Limit.”
• To set the Minimum volume setting, select “Min Volume.” Use the Volume/Scroll knob to adjust the level and press ENTER to save.
• To set the Maximum volume setting, select “Max Volume.” Use the Volume/Scroll knob to adjust the level and press ENTER to save.
Congure Stage Announce and SA Relay
From the BeltStation:
• To set Stage Announce, press MENU; select “Set Controls;” select “Stage Announce;” select “Momentary.” This is the default setting.
• To set SA Relay, press MENU; select “Set Controls;” select “Stage Announce;” Select “SA Relay Enable.” This is the default setting.
From the BaseStation:
• To set Stage Announce, select the numbered key 1 through 5 that corresponds to the BeltStation desired.
• Select “Stage Announce,” select “S/A Audio,” select Momentary.
• Press MENU to go up one level in the menu.
• Select “Stage Announce” to set “SA Relay” and select SA Relay Enable.
• The STAGE button is always Momentary when enabled.