44
Setting up a Wireless Network Encrypted Using WPA or WPA2
Networking requirement
A highly secure wireless network is required and a RADIUS server is available. In this case, WPA or WPA2
pre-shared key mode is recommended. See the following figure.
Configuration procedure
Configure the AP
Assume that the IP address of the RADIUS server is 192.168.0.200, the Key is 12345678, and the port number
for authentication is 1812.
Assume that the second SSID of the AP is used.
Step 1 Choose Wireless Setting > SSID Settings.
Step 2 Select the second SSID from the SSID drop-down list box.
Step 3 Select the Enable check box.
Step 4 Change the value of the SSID text box to hot_spot.
Step 5 Set Security Mode to WPA2.
Step 6 Set RADIUS Server IP, RADIUS Port, and RADIUS Password to 192.168.0.200, 1812, and 12345678
respectively.
Step 7 Set Encryption Algorithm to AES.
Step 8 Click Save.
RADIUS server
IP: 192.168.0.200
To Next Page
Loading...
