35
7.1.2 Modifying SSID Settings
To change the related settings of an SSID, perform the following procedure:
Step 1 Choose Wireless Setting> SSID Settings.
Step 2 Click the tab to choose the radio band to be set.
Step 3 Change the parameters as required. Generally, you only need to change the Enable, SSID, and
Security Mode settings.
Step 4 Click Save.
---End
Parameter description
It specifies the SSID to be configured.
The AP supports 8 SSIDs for the 2.4 GHz and 4 SSIDs for the 5 GHz, and the first SSID displayed is the
primary SSID.
It specifies whether to enable the selected SSID.
By default, the primary SSID is enabled. While the other SSIDs are disabled. Users can enable them if
needed.
It specifies whether to broadcast the selected SSID.
Enable: It indicates that the AP broadcasts the selected SSID. In this case, nearby wireless clients
can detect the SSID.
Disable: It indicates that the AP does not broadcast the selected SSID. In this case, if you want to
connect a wireless client to the wireless network corresponding to the SSID, you must manually
To Next Page
Loading...
Need help?
General
