Tenda 11AC - QVLAN Settings; Overview; Configuring the QVLAN Function

75
7.7 QVLAN Settings
7.7.1 Overview
The AP supports 802.1Q VLANs and is applicable in a network environment where 802.1Q VLANs have been
defined. By default, the QVLAN function is disabled.
7.7.2 Configuring the QVLAN Function
Step 1 Choose Wireless Setting > QVLAN Settings.
Step 2 Change the parameters as required. Generally, you only need to change the Enable, LAN Port, 2.4
GHz SSID VLAN ID and 5 GHz SSID VLAN ID settings.
Step 3 Click Save.
---End
Parameter description
Parameter
Description
Enable
It specifies whether to enable the QVLAN function of the AP. By default, it is disabled.
PVID
It specifies the ID of the default native VLAN of the trunk port of the AP. The default value is 1.
Management VLAN
It specifies the ID of the AP management VLAN. The default value is 1.
After changing the management VLAN, you can manage the AP only after connecting your computer
or AP controller to the new management VLAN.
Trunk Port
It specifies the LAN port used as a trunk port of the AP. The default value is LAN0.Traffic of all VLANs
can pass through a trunk port.
*
*
*