Tenda 11AC User Manual

81
8.2 Configuring the SNMP Function
Step 1 Choose SNMP and set SNMP Agent to Enable.
Step 2 Set related SNMP parameters.
Step 3 Click Save.
---End
Parameter description
Parameter
Description
SNMP Agent
It specifies whether to enable the SNMP agent function of the AP. By default, it is disabled.
An SNMP manager and the SNMP agent can communicate with each other only if their SNMP
versions are the same. Currently, the SNMP agent function of the AP supports SNMP V1 and SNMP
V2C.
Administrator
It specifies the name of the administrator of the AP. The default name is Administrator. You can
change the name as required.
Device Name
It specifies the device name of the AP. The default device name is the model of the AP.
It is recommended that you change the AP name so that you can easily identify the AP when
managing the AP using SNMP.
Location
It specifies the location where the AP is used. The default location is ShenZhen. You can change the
location as required.
Read Community
It specifies the read password shared between SNMP managers and this SNMP agent. The default
password is public.
The SNMP agent function of the AP allows an SNMP manager to use the password to read variables
in the MIB of the AP.
Read/Write Community
It specifies the read/write password shared between SNMP managers and this SNMP agent. The
default password is private.

Tenda 11AC Specifications

General

Brand	Tenda
Model	11AC
Category	Wireless Access Point
Language	English