89
9.3 Logs
This module enables you to view logs and configure log settings.
9.3.1 Viewing Logs
The logs of the AP record various events that occur and the operations that users perform after the AP starts.
In case of a system fault, you can refer to the logs during troubleshooting.
To access the page, choose Tools > Logs.
To ensure that the logs are recorded correctly, verify the system time of the AP. You can correct the system
time of the AP by choosing Tools > Time & Date > System Time.
To view the latest logs of the AP, click Refresh. To clear the existing logs of the AP, click Clear.
When the AP reboots, the previous logs are lost.
The AP reboots when the AP is powered on after a power failure, the QVLAN function is configured, the firmware is
upgraded, an AP configuration is backed up or restored, or the factory settings are restored.
9.3.2 Configuring Log Settings
To access the page, choose Tools > Logs and click Log Settings.
On this page, you can set the number of logs to be displayed and configure log servers.
To Next Page
Loading...
Need help?
General
