Standard Operating Procedures 7
1-June-2014 United Kingdom Operations Manual
Page 7 - 2 TA9 & 10 Tier 4
7.3 To Lower the ROP’s for Transport
7.4 Machine Access
Steps and grab handles are provided each side of the machine, refer to Figure 7.2. These must
be used when mounting or dismounting to avoid personal injury. Always face the machine and
maintain 3 points of contact at all times; either 2 hands and 1 foot or 2 feet and 1 hand. Never
jump from the machine.
Figure 7.2 - Machine Access Points
1. Grab Handles
2. Access Steps
PROCEDURE
1. Remove the linch pins from the locking pins.
2. Remove the locking pins.
3. Push the top section of the ROP’s upwards to its working position.
4. Refit the locking pins and secure with the linch pins.
5. Fit the beacon.
PROCEDURE
1. Remove the beacon.
2. Remove the linch pins from the locking pins.
3. Remove the locking pins.
4. Lower the top section of the ROP’s downwards.
5. Refit the locking pins and secure with the linch pins.
To Next Page
Loading...
Need help?
General
