Operations Manual United Kingdom 1-June-2014
TA9 & 10 Tier 4 Page 7 - 9
Standard Operating Procedures 7
7.10 Loading the Skip
Before the skip is loaded the operator should:-
• Park the machine safely.
• Apply parking brake and stop engine.
• Get off the machine and stand clear.
7.11 Skip Operation
(1) To Tip the Load
Refer to Figure 7.8
Figure 7.8. - Control Lever - Forward Tip
1. Control Lever
bWARNING
It is important to get off the machine and stand clear when loading the skip using a backhoe
loader, digger, loader shovel or similar equipment to prevent injury from falling objects.
PROCEDURE
1. Position the machine where the load is to be discharged.
2. Make sure the area is clear of bystanders.
3. Push the control lever forwards (A) towards the front of the machine; the skip will tip and
the load will be discharged.
To Next Page
Loading...
Need help?
General
